1. Upon receiving an enquiry, Geotech will arrange for their expert team to visit the potential site, to ascertain the viability of their Geobind system.

2. On receipt of confirmation to proceed from the client, DCP or dynamic cone penetrometer testing is undertaken to establish the ground strength at the formation of the stabilised layer.

3. Material samples are also taken from site, and delivered to a laboratory to confirm proposed mix designs and soil properties.

4. On receipt of an order, Geotech can mobilise to site within 7 days. An onsite laboratory is set up.

5. Top soil strip of the set-out areas is undertaken.

6. Mixing commences using specialist plant, which rotavates Geobind in situ with site won material.

7. Correct moisture content is a vital part of the stabilisation process. Water is added if necessary.

8. The area is then trimmed and compacted.

9. Selected Surfacing is applied.

10. Given optimum conditions, 3,000 square metres, or half a kilometre of haul road per day, can be completed.

11. Throughout this process, on-site testing by a UKAS registered laboratory is undertaken.

12. UKAS validation testing is undertaken after 48 hours, to ascertain required strengths have been achieved, after which site trafficking can commence.

Loading animation...

Do you have a Question?

Use the form below to email us, or call 01189 796 897.

Opt In

2 + 3 =

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this. For more information on our use of Cookies, see our privacy policy.